Description
The required clearance from combustible materials must be maintained on all heaters. In addition heaters must have adequate fresh air and ventilation to operate properly. Make sure you can meet these requirements in making your heater selection.
S25 offers a lower radiant heat output which allows this heater to be located in patios with limited ceiling height.
S34 offers a greater radiant heat output which allows this heater to be located higher. Also note the above and side clearance requires increases with the higher BTU/Hr unit.
This heater requires a 24 VAC source and switch or timer or other control device. This control device is to be supplied by the installer
S25, S34 Specifications
- 25,000 btu (S25) or 34,000 btu (S34)
- Black or Stainless Steel
- Single-Stage Control
- Natural Gas or Propane
- 24 VAC – 20 VA
- Electronic Ignition
- Wall or Ceiling Mounted
- CSA Design Certified
- Rain Protected
- Optional Beveled Face Trim
| Model | BTU/h | Side In | Rear In | Ceiling In | Below In | Mtg Angle |
|---|---|---|---|---|---|---|
|
S25
|
25,000
|
24″
|
12″
|
9″
|
48″
|
Horizontal
|
|
S34
|
34,000
|
24″
|
17″
|
13″
|
48″
|
Horizontal
|
|
S25*
|
25,000
|
24″
|
8″
|
14″
|
48″
|
30° Max
|
|
S34
|
34,000
|
24″
|
8″
|
18″
|
48″
|
30° Max
|
Above clearances apply to Natural and Propane.
*Model S25 for propane gas for use in horizontal position only.
Sunpak Standard Models – Natural Gas
| Item No. | Model | BTU Range | Gas Type | Finish | Electrical | Wt. |
|---|---|---|---|---|---|---|
|
12001-2
|
S25
|
25,000 Btu/hr
|
Natural Gas
|
Black
|
24 VAC / 20 VA
|
41 lbs
|
|
12002-2
|
S34
|
34,000 Btu/hr
|
Nautral Gas
|
Black
|
24 VAC / 20 VA
|
41 lbs
|
|
12001-4
|
S25 SST
|
25,000 Btu/hr
|
Natural Gas
|
Stainless Steel
|
24 VAC / 20 VA
|
41 lbs
|
|
12002-4
|
S34 SST
|
34,000 Btu/hr
|
Natural Gas
|
Stainless Steel
|
24 VAC / 20 VA
|
41 lbs
|
Specification: Patio Heater shall be Sunpak Model S25 or S34 , utilizing a ceramic burner, electronic ignition, flame rectification safety, operating with 24 VAC control. Heater casing to have dimensions of 8″ x 8″ x 48″ long and the heater must be CSA design certified for outdoor use. Follow Manufacturer’s clearance to combustibles requirements.
Mounting kit should be specified as Item No. 12006 – Mounting Kit Black or 12006-6 Mounting Kit Stainless. Kits are universal to all Sunpak models.
Standard Models – Propane
| Item No. | Model | BTU Range | Gas Type | Finish | Electrical | Wt. |
|---|---|---|---|---|---|---|
|
12003-2
|
S25 LP
|
25,000 Btu/hr
|
Propane
|
Black
|
24 VAC / 20 VA
|
41 lbs
|
|
12004-2
|
S34 LP
|
34,000 Btu/hr
|
Propane
|
Black
|
24 VAC / 20 VA
|
41 lbs
|
|
12003-4
|
S25 SST LP
|
25,000 Btu/hr
|
Propane
|
Stainless Steel
|
24 VAC / 20 VA
|
41 lbs
|
|
12004-4
|
S34 SST LP
|
34,000 Btu/hr
|
Propane
|
Stainless Steel
|
24 VAC / 20 VA
|
41 lbs
|
Reviews
There are no reviews yet.